DENSITY SENSOR OUT OF RANGE Alternates with CLEAN DENSITY SENSOR

Description
A density sensor out-of-range error was detected during a color calibration.

Action
The density sensor might be dirty. Inspect and clean the sensor.

CAUTION: Use only HP-recommended cleaning materials.

Open the lower-front drawer, and remove the cleaning brush mounted inside (Figure 1, call-out 1).
Open the top-front drawer, and remove the imaging drum using the blue handle.
Using the cleaning brush, remove all dust and toner particles from the sensor (Figure 1, call-out 2).
Place the imaging drum back inside the printer.

Figure 1: Cleaning the Density Sensor

1 - Opening the top drawer and middle front drawer
2 - Cleaning the Density Sensor with the cleaning brush

© 2005 Hewlett-Packard