Xerox 4525 Maintenance Reset Procedure

The Maintenance Kit is a user installable kit which replaces the paper feed rollers, bias transfer roller,cleaning cloth, gloves and fuser. The printer's control panel display informs the user when it is time to install a Maintenance Kit.

DocuPrint N4525 Maintenance Kit

Upon completing the Maintenance Kit installation, it is necessary to reset the Maintenance Kit Counter.

Note: The Maintenance Kit Counter should only be reset when a complete kit has been installed.

Maintenance Kit Counter Reset Procedure

1. Make certain the printer is OFF.

2. Press and hold buttons 2 and 6 on the control panel while you switch ON printer main power. Continue holding until *IOT?* appears in the display (approximately 20 seconds).

3. When the control panel shows *IOT?* , release buttons 2 and 6, then press and hold buttons 0 and 5. Hold 0 and 5 until "Reset Complete Please Reboot" is displayed. This message confirms the counter has been reset.

4. Reboot the printer by powering OFF, waiting 20-30 seconds and powering ON.

The Maintenance Kit is a customer purchased / customer replaced unit (CRU). The interval for replacement is 3000K prints.