Toner Cartridge Replacement for Okidata Printers

1. Press the cover release and open the printer's top cover fully.

WARNING!
If the printer has been powered on, the fuser is hot. This areas is clearly labelled. Do not touch.

2. Note the positions of the four cartridges: Cyan (1), Magenta (2), Yellow (3), Black (4):

3. Pull the colored toner release lever on the cartridge to be replaced (here we are showing replacement of the black toner cartridge) towards the front of the printer.

4. Lift the right-hand end of the cartridge and then pull the cartridge to the right to release the left-hand end as shown. Remove the toner cartridge and discard it in accordance with your local regulations.

5. Unpack the new toner cartridge and gently shake it from side to side to loosen and distribute the toner evenly inside the cartridge.

6. Remove the adhesive tape from the underside of the cartridge.

CAUTION!
Do not touch the toner release lever until the toner cartridge is installed in the image drum. If you do, it will open the toner release slot and spill toner.

7. Holding the cartridge by its top center with the colored release lever to the right, insert the left end of the cartridge into the top of the image drum, pushing it firmly against the spring on the drum unit.

8. Lower the right end of the cartridge into the image drum unit, pressing it firmly down in place, then push the colored lock lever back to open the toner slot and lock it in place.

Important!
The lever should move easily. If it does not, STOP! and push down on the toner cartridge to be sure that it is properly seated in the image drum, then press back on the lever again.

To avoid toner spillage, do NOT open the toner release lever until the toner cartridge is firmly seated in the image drum.

9. Close and latch the top cover.

©2005 Oki Data Americas, Inc.