Installing the Duplex Option

Konica-Minolta Duplexer, 1710579-100

 1. Turn off the printer.

2. Remove the cover on the right side cover.

3. Remove the door at the side of the right side cover.

4. Prepare the duplex option. Before installing the duplex option, open the duplex cover, and then check that the knob is positioned as shown in the illustration. Then, close the duplex cover.

5. Attach the duplex option, as shown in the illustration.

6. Open the duplex cover, and then turn both knobs counterclockwise until they are horizontal to secure the duplex option to the right side cover.

7. Pull the lever, open the right side cover, and then attach the support wire for the duplex option to the printer.

8. Close the right side cover.

9. Reboot the printer (turn it off, wait 30 seconds and turn it back on).

10. Print a configuration page from the printer control panel to verify the duplex option installation.

11. Configure the driver for the new duplex option.