 MSDS Sheet # 58356601 For Black Toner, Type 9, Part #'s 42103001 & 42102901
For more information, contact Oki Data at: 2000 Bishops Gate Blvd., Mount Laurel, NJ 08054-4620
Emergency Information: call 1-800-OKIDATA; U.S. and Canada only
Emergency First Aid Procedures
Toner swallowed (ingested).
Immediately seek medical attention. Never give anything by mouth to an unconscious person. If possible, rinse out mouth and give one or two glasses of water or milk to drink.
Toner inhaled.
Remove person to fresh air. Seek medical attention.
Toner gets in the eyes.
Flush eyes with quantities of cool water for 15 minutes, keeping the eyelids open with fingers. If necessary, seek medical attention.
Toner gets on the skin.
Wash toner off the skin with plenty of cool water and soap. If necessary, seek medical attention.
Note: Small amounts of toner on skin or clothing can easily be removed with soap and cold water. Hot water makes toner harder to remove.
Hazardous Ingredients
Styrene-Butyl Acrylate Copolymer (84% by weight)
CAS#: 25767-47-9
OSHA TWA: 15 mg/m3 for total dust
ACGIH TLV: 10 mg/m3 for total dust
Carbon Black (5-7% by weight)
CAS#: 1333-86-4
OSHA TWA: 3.5 mg/m3
ACGIH TLV: 3.5 mg/m3
Fatty acid ester (5-10% by weight)
CAS#: 61682-73-3
OSHA TWA: --
ACGIH TLV: --
Carcinogens
Carbon Black
IARC -2B
Physical/Chemical Characteristics
 | Melting Point: 110oC (230oF)
Boiling Point (Softening Point): Not applicable
Vapor Pressure mmHg: Not applicable
Vapor Density (Air=1): Not applicable
Evaporation Rate: Not applicable
Specific Gravity (H2O=1): 1.15
Solubility in water: Negligible
Appearance and odor: Black powder, odorless |
Fire and Explosion Hazard Data
Flash Point (Method Used): Not applicable
Flammable Limits Lower Explosive Limit: Not applicable
Upper Explosive Limit: Not applicable Explosion Limits Lower Explosive Limit: 60g/m3
Upper Explosive Limit: Unknown Extinguishing Media: Water, Co2, ABC Dry Chemical, or Protein type air foams.
Special Fire Fighting Procedures: Do not use methods that may create a dust cloud, such as high pressure water and/or steam.
Unusual Fire and Explosion Hazards: Thermal decomposition of organic components may result in release of oxides and carbon and nitrogen. Reactivity Data
Stability: Stable
Conditions to Avoid: Do not expose to temperature above 200oC.
Incompatibility (Materials to Avoid): Avoid exposure to strong oxidizers.
Hazardous Polymerization: Will not occur.
Conditions to Avoid: None.
Hazardous Decomposition Products: Carbon Oxide.
Health Hazard Data
Routes of Entry: Eye Contact: Eye irritation will be caused. If contacted, flush eyes with running water for several minutes with eyelids open. consult an eye doctor.
Skin Contact: No symptoms will appear. It contacted, remove contaminated clothes and wash skin with soap and water.
Inhalation: Lung irritation, difficult breathing, sneezing, coughing, will be caused. If inhaled, remove the sufferer to fresh air and call a physician.
Health Hazards (Acute and Chronic)
Acute Oral Toxicity: LD50>2000mg/Kg(Rat)
Ames Test: Negative
Acute Inhalation Toxicity: LC50>4.98mg/I/(Rat)
Skin Irritation: No irritant (Rabbit)
Eye Irritation: Minimal irritant (Rabbit)
Carcinogenicity: NTP; NL IARC Monograph; NL OSHA Regulated; NL NL; Not Listed
Spill or Leak Procedures
Steps to be taken in case Material is Released or Spilled: Spray water over the spilled and/or leaded materials and then clean out into a container. A vacuum cleaner with explosion-proof can be used for small spills.
Water Disposal Method: Follow appropriate federal, state and local regulations.
Control Measures
Respiratory Protection (Specify Type): Nuisance dust respirator
Ventilation: Local Exhaust-Recommended/Special-not necessary Mechanical (General)-Recommended Other-not necessary
Protective Gloves: Recommended.
Eye Protection: Safety goggles.
Other Protective Equipment: Not Necessary
Special Precaution
Precautions to be taken in handling and storing: Store in dry cool place, Keep from sparks and open flame. Use with adequate ventilation. To avoid dust explosion, ground all equipment and pour material slowly into vessel.
Other Precautions: None
Transportation Information
This product is not regulated as hazardous materials by the DOT.
Regulatory Information
All ingredients are registered under the Toxic Substance Control Act (TSCA) or under polymer exemption. All ingredients are exempt, registered or considered (polymers) under European Inventory of Existing Commercial Chemical Substances (EINECS).
User's Responsibility
This bulletin cannot cover all possible situations which the user may experience during processing. Each aspect of your operation must be examined, if, or where, additional precautions may be necessary. All health and safety information contained in this bulletin must be provided to your employees or customers. It is your responsibility to use this information to develop appropriate work practice guidelines and employee instructional programs for your operation.
Date Prepared: May 28, 2002
Oki Data Americas, Inc. 2000 Bishops Gate Blvd. Mt Laurel, NJ 08054-4620 Tel: (856) 235-2600 FAX: (856) 222-5320
Oki Data Americas, Inc. 2735 Matheson Blvd. East, Unit 1, Mississauga Ontario, Canada L4W 4M8 Tel: (800) 654-3282 FAX: (905) 238-4427
Oki Data de Mexico, S.A. de C.V., Mariano Escobedo No. 748 - 8 Piso, Col Anzures, e. p. 11590, Mexico, DF Tel: +52 55 5263-8780 FAX: +52 55 5263-8783
Oki Data do Brasil, Ltda., Rua Alexandre Dumas, 2220 - 8o andar, Chacara Santo Antonio, 04717-004 Sao Paulo - SO - Brasil Tel: 55-11-3444-3500 FAX: 55-11-3444-3501 Support Center: 0800-11-55-77 Email: okidata@okidata.com.br
|
Glossary
Contact Us
8-5-2005
Views: 2508
7-18-2005
Views: 1660
