 MSDS Sheet # 58367401 For Print Cartridge Toner, Part #'s 52114501 & 52114502
For more information, contact Oki Data at 2000 Bishops Gate Blvd., Mount Laurel, NJ 08054-4620
Emergency Information: call 1-800-OKIDATA; U.S. and Canada only
Emergency First Aid Procedures
Toner swallowed (ingested).
Rinse out mouth with water and give several glasses of water to drink. Seek medical attention.
Toner inhaled.
Remove person to fresh air. Rinse mouth with water.
Toner gets in the eyes.
Flush eyes with large quantities of cool water for 15 minutes, keeping the eyelids open with fingers. Seek medical attention.
Toner gets on the skin.
Wash toner off the skin with plenty of cool water and soap.
Note: Small amounts of toner on skin or clothing can easily be removed with soap and cold water. Hot water makes toner harder to remove.
Hazardous Ingredients
Polyester (40-50% by weight)
CAS#: Not available
OSHA PEL: Not available.
Magnetite (40-50% by weight)
CAS#: 1309-38-2
OSHA PEL: Not available.
Propylene Wax (1-5% by weight)
CAS#: Not available
OSHA PEL: Not available.
Ethylene/Propylene Resin (1-5% by weight)
CAS#: Not available
OSHA PEL: Not available.
Amorphous Silica (1-5% by weight)
CAS#: 7631-86-9
OSHA PEL: Not available.
Physical Data
 | Physical State: Solid
Melting/Freezing Point: Not available
Boiling Point: Not applicable
pH: Not available
Vapor Pressure: Not applicable
Vapor Density (Air=1): Not available
Evaporation Rate (Butyl Acetate=1): Not available
Specific Gravity (H2O=1): Not available
Solubility in water: Negligible
Solubility in Solvents: Not available
Appearance and odor: Black fine powder, no odor
Odor Threshold: Not available |
Fire and Explosion Hazard Data
Flash Point (OoC): Not applicable
Flammability: Not flammable under conditions of use.
Flammable Limits Lower Explosive Limit: Not applicable
Upper Explosive Limit: Not applicable Auto-ignition Temperature: Not applicable
Explosion Data
Like most organic materials in powder form, the toner can form explosive mixtures when dispersed in air. Sensitivity to Mechanical Impact: Not Available
Sensitivity to Static Discharge: Not Available Extinguishing Media: Water spray, foam, dry chemicals.
Special Fire Fighting Procedures: In case of fire, use extinguishing media. When mounted in the printer, treat as an electrical fire.
Toxicological Properties
Routes of Entry: Inhalation, Ingestion, Eyes, Skin.
Effects of Acute Exposure: (based on toxicity data for similar materials and ingredients):
Swallowed LD50 (rat): > 5000 mg/kg
Skin LD50 (rabbit): > 5000 mg/kg
Inhaled LC50 (rat): .5 mg/L/4hr
Effects of Chronic Exposure: (based on toxicity data for similar materials and ingredients): The results obtained from a sponsored, Chronic Toner Inhalation Study, demonstrated no lung change in rats for the lowest (1 mg/m3) exposure level (i.e. the level most relevant to potential human exposure).
A very slight degree of fibrosis was noted in 25% of the animals at the middle (4 mg/m3) exposure level, while a slight degree of fibrosis was noted in all the animals at the highest (16 mg/m3) exposure level.
These findings are attributed to "lung overloading," a generic response to excessive amounts of any dust retained in the lungs for a prolonged period. This study was conducted using a special test toner to comply with EPA testing protocol. The test toner was ten times more respirable than commercially available Oki toner, and would not be functionally suitable for Oki equipment.
Exposure Limits, CGIH TLV*:
Total: 10 mg/m3
Respirable: 10 mg/m3
Irritancy: Not an irritant.*
Sensitization (skin, guinea pig): Not a sensitizer. *
Carcinogencity: Not classified as "Carcinogens" *
IARC: Refer to IARC Monographs on the Evaluation Carinogenic Risks to Humans (WHO International Agency for Research on cancer).
NTP: Refer to National Toxicology Program (NTP) Report on Carcinogens (NTP).
OSHA: Not available.
* Based on toxicity data for similar materials and ingredients.
Reproductive Toxicity: Not classified as "Reproductive and Development chemicals".
Teratogenicity: Not available
Mutagenicity (Ames Assay): Negative.
Name of Toxicologically Synergistic Products: Not available
Reactivity Data
Stability: Stable
Conditions to Avoid: Not available
Polymerization: Not available
Hazardous Decomposition Products: Not available
Incompatibility: Not available.
Preventive Measures
Personal Protective Equipment
Respiratory Protection: Not normally required. For large spills (such as in bulk processing facilities), use dust respirator during cleanup.
Protective Gloves and/or Eye Protection: Not normally required. For large spills (such as in bulk processing facilities), use rubber gloves and safety goggles during cleanup.
Engineering Controls
Ventilation: Outside of normal ventilation, not normally required. In bulk processing facilities, local exhaust ventilation may be required.
Other Protective Equipment and/or Hygienic Practices: None
Spill Cleanup
Small Spills - Remove sources of ignition.
- Sweep up or soak up with a damp (cold water) cloth.
Large Spills - Remove sources of ignition.
- Keep unnecessary and unprotected personnel away from area.
- Wear protective gear: respirator, rubber gloves, goggles.
- After removing the bulk of the spill, wipe up remainder with a wet (cold water) cloth.
- Place waster material in a closed container.
Waste Disposal
Follow appropriate federal, state, and local regulations.
Precautions
Precautions for Handling or Storage: Do not incinerate toner or a print cartridge. Do not disassemble a print cartridge. Keep in a cool, dry, well-ventilated place. Keep out of reach of children.
Other Precautions: None
Shipping Information
Special Shipping Information: Transport in accordance with national and local regulations.
Preparation of MSDS
Date: November 1, 2003
Prepared by:
Oki Data Americas, Inc.
Engineering Services Department
2000 Bishops Gate Blvd.
Mt. Laurel, NJ 08054-4620
Tel: (856) 235-2600
Fax: (856) 222-5320
http://www.okidata.com
http://my.okidata.com
|
Glossary
Contact Us
2-2-2006
Views: 1434
6-15-2005
Views: 2232
10-18-2005
Views: 1508
